Table of Contents
Advertisement
RAID super capacitor module replacement
Use this information to remove and install a RAID super capacitor module.
Your server supports up to two RAID super capacitor modules. The RAID super capacitor holders are located
underneath the air baffle.
Remove a RAID super capacitor module
Use this information to remove a RAID super capacitor module.
"Read the
installation
Guidelines" on
page 45
Before removing the RAID super capacitor module:
1. Remove the top cover. See "Remove the top cover" on page 57.
2. Locate the RAID super capacitor module, and disconnect its cable. The RAID super capacitor holders
are located underneath the air baffle.
3. Remove the air baffle and turn it over. See "Remove the air baffle" on page 60.
To remove the RAID super capacitor module, complete the following steps:
Figure 36. RAID super capacitor module removal
Step 1.
Gently pivot the retaining clip as shown.
Step 2.
Lift the RAID super capacitor up and remove it from the holder.
If you are instructed to return the old RAID super capacitor module, follow all packaging instructions and use
any packaging materials that are provided.
"Power off
the server
for this task"
on page 14
Chapter 3
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 48
.
Hardware replacement procedures
63
Advertisement
Table of Contents
