Table of Contents
Advertisement
2. Push the middle rail back into the outer rail. An audible click indicates that the rail is fully
inserted.
1
3. Insert the pegs on the rear of the outer rail into the rear rack holes. An audible click
indicates that the rail is locked into place.
4. Press upward on the locking tab near the rear end of the middle rail, and extend the
outer rail until the length fits within the posts of the rack.
5. On the front end of the outer rail, turn the latch to the open position and push the pegs
into the front rack holes.
6. Turn the latch to the locked position.
7. Repeat steps 1-6 for the remaining outer rail.
3
5
Figure 2-6. Installing Outer Rails to a Rack
Figure 2-5. Adjusting the Middle Rail
4
6
23
Chapter 2: System Installation
2
Advertisement
Table of Contents
