K-TEK KP Installation & Operation Manual page 9

10. After pulling wires through the conduit entries and inside of the housing, terminate the switch
control wiring to the switch terminals as shown in Figure 6 and Figure 7.
11. Hinge the switch bracket to its lower state and re-tighten the mounting screw until secure.
COMMON
TO
CONTROL
CIRCUIT
OPEN
CLOSED
12. Figure 8 indicates the recommended field wiring paths inside the housing to ensure proper switch
operation and to eliminate crimped wires when the cover is screwed in place. All efforts should be
taken to run the field wiring as shown here.
13. After all wiring terminations are made, screw the cover back on and tighten.
KP-0200-1 Rev f (10-2010) DCN0536
MOTOR
SPDT SWITCHES
COMMON
OPEN
CLOSED
DENOTES FIELD
WIRING
Figure 6
FIGURE 5
Motor Power Terminal Wiring
RATED MOTOR
VOLTAGE INPUT
PER NAMEPLATE
Figure 5
SPDT #1
COMMON
TO
CONTROL
CIRCUIT
PADDLE RESTRICTED OR STOPPED
SPDT #1
COMMON
PADDLE FREE TURNING
CLOSED CLOSED
OPEN OPEN
CLOSED CLOSED
OPEN OPEN
Figure 7
FIGURE 6
SPDT #2
COMMON
SPDT #2
COMMON
9