Table of Contents
Advertisement
D. Side Bin Wall Mounting
1. If flange-mounting plate is used, fully assemble the paddle switch by connecting the paddle to the
power shaft and secure with a 1/8" roll pin.
2. Insert the paddle end of the assembly through the 5-1/2" clear opening and align the flange mount-
ing bolt holes such that the conduit entries on the enclosure are located either on top or the right
hand side when looking at the outside bin wall. Note: The use of a 1/8" gasket is recommended
between the mounting flange and bin wall to reduce vibration transmission.
3. Screw in the six mounting bolts and tighten.
Figure 2.
4. If a half pipe-coupling fitting is to be used, the paddle must be removed prior to insertion and assem-
bled after the paddle housing is secured to the bin wall. Note: Special care should be taken to en-
sure that the paddle assembly is tightened into the pipe coupling by wrench tightening at the ma-
chined flats (1-1/8") below the bottom of the housing only. DO NOT tighten the housing into the cou-
pling by turning the housing itself.
3/4" CONDUIT ENTRY
KP-0200-1 Rev f (10-2010) DCN0536
1/8" GASKET
RECOMMENDED
MOUNTING FLANGE
(MOUNTING BOLTS
NOT SHOWN)
FIGURE 2
Figure 2
The final assembly should be installed as per
BIN WALL
HALF PIPE
COUPLING
FLEX COUPLING
(OPTIONAL)
PADDLE
6
Advertisement
Table of Contents
