Table of Contents
Advertisement
C. Paddle Assembly Instructions
The paddle must be assembled per the steps delineated below in Figure 1 prior to unit
operation.
Paddle Pin Removal: Use a 0.125" diameter center punch or a 0.125" wide flat screwdriver to drive
the paddle pin out of the paddle shaft for paddle removal.
KP-0200-1 Rev f (10-2010) DCN0536
Step 1
Slide paddle center bar over
paddle switch stub shaft
Align Pin
Holes
Figure 1
CAUTION!
Roll
Do not hammer
Pin
paddle onto switch
stub shaft!
It should slide on
easily. If not, clean
all mating surfaces
Step 3
Gently tap in roll
pin with hammer
Step 2
Piece of 2x4 or
similar for support
(if possible)
5
Advertisement
Table of Contents
