Return; Disposal; Firmware History; Contact Addresses At Endress+Hauser - Endress+Hauser Solicap M FTI55 Operating Instructions Manual

9.3

Return

You must take the following measures before returning a measuring device to Endress+Hauser, for
example for repair:
• Remove all traces of the medium. Pay particular attention to crevices and grooves for seals into
which the medium can penetrate. This is particularly important if the medium is hazardous to
health, e.g. combustible, toxic, caustic, carcinogenic etc.
• Always enclose a fully completed "Declaration of contamination" form with the device (a master
copy of the "Declaration of contamination" form can be found at the end of these Operating
Instructions). Only then can Endress+Hauser check or repair a returned device.
• If necessary, enclose special handling instructions when returning the device, e.g. a safety data
sheet in accordance with EN 91/155/EEC.
In addition, specify the following:
• The chemical and physical properties of the medium
• A description of the application
• A description of the fault that occurred
• Operating time of the device
9.4

Disposal

At disposal, ensure that materials are properly separated and the device components are reused.
9.5

Firmware history

• FW electronic insert FEI52: V 01.00.00
• FW electronic insert FEI54: V 01.00.00
• FW electronic insert FEI55: V 01.00.00
• FW electronic insert FEI53: V 01.00.00
• FW electronic insert FEI57S: V 01.00.00
9.6

Contact addresses at Endress+Hauser

On the back page of these Operating Instructions, you can find an internet address for
Endress+Hauser. The web site provides contact addresses that you can use in case of any questions.
Troubleshooting
63