Loading Paper; Replacing An Outdated Ink Cartridge - Epson Stylus Color 800N Specifications

EPSON Stylus COLOR 800N
3. Lower the ink cartridge into its holder with the label facing
up and the arrow pointing to the back of the printer.
4. Press down the ink cartridge clamp until it locks in place.
5. If you need to replace the other ink cartridge, follow the
steps under "Removing an Empty Ink Cartridge," and then
steps 1 through 4 under "Installing the New Cartridge."
6. Press the load/eject button and close the printer cover.
E
The printer moves the print heads and begins charging the
ink delivery system. (Even if you don't press the button, ink
charging begins 60 seconds after you close the clamp.)
The power light flashes, and the printer makes various
P
sounds. Charging takes about two minutes. When it's
finished, you can print again.
Caution:
Don't turn off the printer while the
flashing, unless the printer has not moved or made
noise for more than 5 minutes.

Replacing an Outdated Ink Cartridge

If an ink cartridge is more than six months old, you may need
to replace it. How can you tell? You may notice that your
printouts don't look as good as they used to. If print quality
doesn't improve after cleaning and aligning the print heads,
you can replace one or both cartridges.
Follow these steps to replace an ink cartridge before the
black or color ink out light is flashing or on:
A
1. Make sure the printer is turned on and not printing.
2. Lower the output tray and raise the printer cover. Then
locate the Y black and X
control panel under the printer's cover.
8 - EPSON Stylus COLOR 800N
P
power light is
color cleaning buttons next to the
3. Press both the
them down for a few seconds until the print heads move to
the left.
Caution:
To avoid damaging the printer, never move the print
heads by hand.
To replace the black ink cartridge, follow the instructions
beginning with step 4 on page 7.
To replace the color ink cartridge, press the
cleaning button and hold it down for a few seconds. After
the color ink cartridge moves to the left, follow the
instructions beginning with step 4 on page 7.

Loading Paper

1. Slide the left edge guide all the way left and pull out the
output tray extensions.
2. Fan a stack of plain paper and then even the edges.
3. Load the stack with the printable surface face up. Push the
paper against the right edge guide.
B
10/97
black and color cleaning buttons and hold
Y X
X color
arrow mark