Removing An Empty Ink Cartridge; Installing The New Cartridge - Epson Stylus Color 800N Specifications

Epson stylus color 800n: specifications
Hide thumbs Also See for Stylus Color 800N:
Table of Contents

Advertisement

Removing an Empty Ink Cartridge

You can replace a cartridge when the
out light is either flashing or on. Make sure the printer is
turned on and not printing before you start. Then follow these
steps:
Caution:
To avoid damaging the printer, never move the print
heads by hand.
1. Determine which cartridge needs to be replaced.
2. Lower the output tray and raise the printer cover. Then
locate the
black and
Y
X
control panel under the printer's cover.
3. Press the
black or
color cleaning button and hold it for
Y
X
three seconds.
Caution:
If you press the cleaning button when no ink out light
is flashing or on, the printer cleans the print heads, as
described on page 11. If you need to replace an ink
cartridge before the lights flash (because the ink is too
old, for example) follow the instructions on page 8.
The print heads move slightly left and the
begins flashing. (The print heads return to their home
position if you don't proceed to step 4 within 60 seconds.)
4. Pull up the ink cartridge clamp. (Although the illustration
shows the black ink cartridge, the procedure is the same for
replacing the color ink cartridge.)
Caution:
Don't open the clamp or remove a cartridge except to
replace it with a new one. Once you remove a
cartridge, you can't reuse it, even if it contains ink.
B
black or
A
color ink
color cleaning buttons next to the
black cleaning
button
color cleaning
button
power light
P
The cartridge rises up from its holder.
5. Lift the cartridge out of the printer and dispose of it
carefully.
Warning:
If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets into your eyes, flush them
immediately with water.
6. Follow the steps in the next section to install the new ink
cartridge.

Installing the New Cartridge

Once you have removed the empty cartridge, you're ready to
install the new one. Follow these steps:
1. Remove the new ink cartridge from its packaging.
2. Remove the yellow tape seal as shown:
black cartridge
Caution:
You must remove the yellow tape seal from the top of
the cartridge; leaving the tape on will permanently
damage it. Do not remove the clear seal from the
bottom of the cartridge; ink will leak out.
10/97
EPSON Stylus COLOR 800N
color cartridge
EPSON Stylus COLOR 800N - 7

Advertisement

Table of Contents
loading

Table of Contents