Advertisement
When Driving
Mazda Radar Cruise Control with Stop & Go function
(MRCC with Stop & Go function)
Do not use the MRCC with Stop & Go function system in the following
locations. Using the MRCC with Stop & Go function system at the following
locations may result in an unexpected accident:
• General roads other than highways
• Roads with sharp curves and where vehicle traffic is heavy with
insufficient space between vehicles, or roads where frequent and
repetitive acceleration and deceleration occur.
• When entering and exiting interchanges, service areas, and parking areas
of highways.
• Slippery roads such as ice or snow-bound roads
• Long, descending slopes.
• Slopes with a steep gradient.
• Two-wheeled vehicles such as motorcycles or bicycles are ahead.
For safety purposes, switch the MRCC with Stop & Go function system
off when it is not being used.
Leaving the MRCC with Stop & Go function system turned on when it is not
in use is dangerous as it could operate unexpectedly, resulting in an accident.
Do not get out of the vehicle while the stop hold control is operating:
Getting out of the vehicle while the stop hold control is operating is dangerous
as the vehicle may move unexpectedly and result in an accident. Before getting
out of the vehicle, switch the MRCC with Stop & Go function system off, shift
the selector lever to the P position, and apply the parking brake.
28
For details, refer to Section 4, "i-ACTIVSENSE".
WARNING
Advertisement
