5. Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to Atrix International. 6. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges of corners.
Page 3
GETTING TO KNOW YOUR BACK PACK VACUUM 1. Main Unit 15. Telescopic Tube...
2. Exhaust Grill 16. Waist Band Back Support Panel 3. On/Off Power Switch 17. Waist Band 4. Canister Lid Tabs 18. Dusting Brush 5. Waist Band 19. Crevice Tool 6. Shoulder Straps 20. Blower Port 7. Back Board Panel 21. Pet Hair Remover 8.
Page 5
Fig.1 unit with the hose opening on the right 3. Pull the tab on the HEPA dust bag holder out or left, as per your preference. (Fig 5) slightly and flip upwards.(Fig 2) 4.Holding the HEPA dust bag in your hand, slide it firmly between the slots in the bag holder.
Page 6
Push the handle in. (Fig. 7) Fig 10 Using the Floor to Carpet Brush 1. To attach the floor to carpet brush to Fig. 7 the telescopic tube, insert the telescopic 2 Push forward on the plastic button and tube into carpet to floor brush. (Fig.11) pull the inner tube outward to extend for a longer reach.
Page 7
unwanted pet hair. control on the top of the brush. Note: This tool is not a grooming tool Open or close to increase or decrease and should not be used on animals. the suction as desired, I, e, open for high Caution: Do not vacuum pet hair.
Page 8
Fig.14 4. To attach the hose to the blower port,align the flexible hose and turn counter-clockwise until it stops.The hose is now securely in place. (Fig. 15) Fig. 15 Operating Instructions Warning: To reduce the risk of electric shock, the power cord must be disconnected before removing the dust bag, shake-out bag, changing the filters or performing maintenance or trouble- shooting checks.
Page 9
press on the canister lid tabs on each side of the unit and lift canister lid.(Fig.19) 6. Replace the shake-out bag into the vacuum. 7. To replace the HEPA dust bag holder, flip the holder and press tab until it clicks. 8.
Page 10
1. Remove the shake-out bag, empty bag. Pull up near the tabs on the motor filter, lift the form the vigorously out doors until there is no sides of the HEPA filter. This is a press fit system. more dust. 2.
Page 11
(1) year from the date of purchase. Should any failure to conform to this warranty appear within this period, Atrix will, at its option, repair or replace the defective product.
Need help?
Do you have a question about the VACBP2 and is the answer not in the manual?
Questions and answers