5. Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to Atrix International. 6. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges of corners.
Page 3
GETTING TO KNOW YOUR Ergo Series VACUUM 1. Replacement 1.5” Lid Grey (VACBPAILIDG) 1A Replacement Latch (BP34-38) 1B Replacement Handle, Webbing and Harness Assembly (VACBPHARNESS) 2. Replacement Hose (VACBPAI39) 3. Floor Tool w/Scallops (VACBPAI34) 4. Crevice Tool (VACBPAI36) 5. Round Dusting Brush (VACBPAI33) 6.
11 and 12. HEPA Pre-Motor Filter and Exhaust Filter (BPFILPACK) 13. Exhaust Filter Cover (BP18) Operating Instructions Warning: To reduce the risk of electric shock, the power cord must be disconnected from the power source before removing and replacing filters or performing maintenance.
Cleaning the HEPA Pre-motor Filter 1. Press/pinch both tabs and pull upwards on filter. 2. Tap out the contents of the HEPA filter over a garbage can. 3. If necessary, thoroughly rinse the HEPA filter using regular tap water. Then shake off any excess water and allow to dry completely before reinserting it.
Page 6
Assembling Your Vacuum Push/press fit the hose into the lid opening. (Fig 7) Fig. 8 Fig. 7 To connect the hose and attachment wand, slide the hose over the hose end wand attachment and over the bump by approx. ½”. (Fig. 8) ...
Page 7
Using Your Vacuum 1. Connect the extension cord to extension cord relief (BP99) (Fig 12) and connect vacuum plug to extension cord. Plug extension cord into 400 Hz power supply. 2. Connect hose and wand and/or utensil. 3. Correctly place shoulder straps on each shoulder and secure the waist band with hook and loop strips. (Fig.
Page 8
(1) year from the date of purchase. Should any failure to conform to this warranty appear within this period, Atrix will, at its option, repair or replace the defective product. It is the user’s responsibility to return the product, freight prepaid, to Atrix International.
Need help?
Do you have a question about the VACBPAI400 and is the answer not in the manual?
Questions and answers