Operation
EMU33120
Procedure for tilting down (power
trim and tilt models)
1.
Push the power trim and tilt switch "
(up) until the outboard motor is support-
ed by the tilt rod and the tilt support lever
becomes free.
2.
Release the tilt support lever.
3.
Push the power trim and tilt switch "
(down) to lower the outboard motor to
the desired position.
UP
DN
DN
40
"
EMU28060
Cruising in shallow water
The outboard motor can be tilted up partially
to allow operation in shallow water.
EMU28080
Hydro tilt models
The outboard motor can be tilted up partially
ZMU02569
to allow operation in shallow water.
EWM00270
"
Place the gear shift in neutral before us-
G
ing the shallow water cruising system.
Run the boat at the lowest possible
G
speed when using the shallow water
cruising system.
Use extra care when operating in re-
G
verse. Too much reverse thrust can
cause the outboard motor to lift out of
the water, increasing the chance of ac-
cident and personal injury.
ZMU01936
Return the outboard motor to its normal
G
position as soon as the boat is back in
deeper water.
ECM00260
CAUTION:
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
WARNING
DN
ZMU03838