Cleaning And Maintenance; Disposal And Recycling - EINHELL EXPERT TE-CC 315 U Original Operating Instructions

Anleitung_TE_CC_315_U_SPK8__ 19.11.12 15:56 Seite 35
6.2.2 Cutting narrow workpieces (Fig. 59)
Be sure to use a push stick (6) when making
n
longitudinal cuts in workpieces smaller than 120
mm in width.
A push stick is supplied with the saw.
Replace a worn or damaged push stick
immediately.
6.2.3 Cutting very narrow workpieces (Fig. 60)
Be sure to use a push block (C) when making
n
longitudinal cuts in very narrow workpieces with a
width of 1.18 in and less.
The low guide face of the parallel stop is best
n
used in this case.
There is no push block supplied with the saw!
(Available from your specialist dealer)
Replace the push block without delay when it
becomes worn.
6.2.4 Completing angular cuts (Fig. 61)
Angular cuts must always be used using the parallel
stop (3).
Set the blade (12) to the desired angle (see
n
6.1.3).
Set the parallel stop (3) in accordance with the
n
workpiece width and height (see 5.3.1).
Carry out the cut in accordance with the
n
workpiece width (see 6.2.1 – 6.2.3).
6.3 Working with the sliding table
6.3.1 Completing cross cuts (Fig. 62-63)
Pull the sliding table (15) forward.
n
Set the cross stop (11) to the required angle
n
dimension and clamp it in place on the sliding
table (15) (see 5.3.2).
Press the workpiece firmly against the cross stop
n
(11) and push the sliding table (15) slowly toward
the blade (12).
Always push the sliding table (15) forward to the
n
point where the workpiece is cut all the way
through.
Switch off the saw again. Important: Do not
n
remove the offcut until the blade (12) has stopped
rotating.
6.3.2 Making edging cuts with the sliding table
(Fig. 64)
The edging process removes the inner and outer bark
from a board and cuts it parallel.
Pull the sliding table (15) forward.
n
Place the workpiece on the sliding table and
n
press it firmly against the auxiliary edging plate
(16)
Push the sliding table (15) with the workpiece
n
toward the blade (12) and make the cut.

7. Cleaning and maintenance

Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
n
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
n
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts
of the equipment. Ensure that no water can seep
into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
35