HAMPTON BAY YG763-BN Use And Care Manual page 11

Assembly — Hanging the Fan (continued)
Preparing the receiver and
7
remote control
NOTE: The frequencies on your receiver and remote control
have been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and remote
control are set to the same frequency. The dip switches on
the remote control are located inside the battery
compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
remote control. Dispose of the used battery properly and keep
the battery out of the reach of children.
Setting the Code on the Remote:
□
Remove the battery cover on the back of the remote
control (M) by pressing firmly on the arrow and
sliding the cover off.
□
Slide the code switches to your choice of either up or
down. The factory setting is up.
□
Install two AAA batteries (DD) (included).
□
Replace the battery cover on the remote control (M).
Setting the Code on the Receiver:
□
Slide the code switches on the receiver (L) to the
same positions as set on the remote control (M).
□
After checking the switches, insert the receiver (L)
into the mounting bracket (A) with the flat side of the
receiver (L) facing the ceiling.
DD
L
F
11
Please contact 1-855-HD-HAMPTON for further assistance.
M
L
HAMPTONBAY.COM
A