Flash Streamer Air Cleaning Operation; To Start/Stop Flash Streamer Operation; Off/On Timer Operation; To Start/Stop Off Timer Operation - Daikin CTXJ25TVMAW Operation Manual

• OUTDOOR UNIT QUIET operation will not reduce the
frequency nor fan speed if they already are operating at
reduced levels.
• This operation is performed with lower power and therefore
may not provide a suffi cient cooling (heating) effect.
Possible combinations of ECONO / OUTDOOR UNIT QUIET
operation and basic operations
AUTO
ECONO
OUTDOOR UNIT
QUIET

4-4 Flash streamer air cleaning operation

Streamer generates a high-speed electron stream with a high
oxidizing power, reducing bad odours and viruses. Together
with the titanium apatite deodorising fi lter and the air fi lters, this
function cleans the air in the room.
INFORMATION
• The high-speed electrons are generated and go away inside
the unit to ensure safe operation.
• The streamer discharge may generate a fi zzing sound.
• If the airfl ow becomes weak, the Streamer discharge may
stop temporarily to prevent ozone smell.
• If the airfl ow rate is set to indoor unit quiet, the Streamer will
not function (for 25 / 35 class).

4-4-1 To start/stop Flash streamer operation

1. Press .
Result:
is displayed on the LCD and the air in the room
is cleaned.
2. To stop operation, press
Result: disappears from the LCD and operation stops.

4-5 OFF/ON timer operation

Timer functions are useful for automatically switching the air
conditioner on/off at night or in the morning. You can also use
OFF timer and ON timer in combination.
INFORMATION
Programme the timer again in case of:
• A circuit breaker has turned the unit off.
• A power failure.
• After replacing batteries in the remote controller.
INFORMATION
The clock MUST be set correctly before using any timer
functions. Refer to "3-3-1 To set the clock" on page 6.
11
Operation
DRY COOL HEAT FAN
-
.

4-5-1 To start/stop OFF timer operation

1. Press
Result:
lights up, and
disappear from the LCD.
2. Press
or
-
3. Press
-
Result: and the set time are displayed on the LCD.
Result: The timer lamp lights up.
INFORMATION
Each time
by 10minutes. Holding the button down will change the
setting rapidly.
4. To stop operation, press
Result:
lamp goes off. and the day of the week are displayed on the LCD.
INFORMATION
When you set the ON/OFF timer, the time setting is stored
in the memory. The memory will be reset when the remote
controller batteries are replaced.

4-5-2 To start/stop ON timer operation

1. Press
Result:
lights up, and
disappear from the LCD.
2. Press
or
3. Press
Result:
and the set time are displayed on the LCD. The
timer lamp lights up.
INFORMATION
Each time
by 10 minutes. Holding the button down will change the
setting rapidly.
to start.
is displayed on the LCD, the timer lamp
blinks. and the day of the week
to change the time setting.
again.
or is pressed, the time setting advances
.
and disappear from the LCD and the timer
to start.
is displayed on the LCD, the timer lamp
blinks. and the day of the week
to change the time setting.
again.
or is pressed, the time setting advances