Advertisement
Quick Links
User Manual ► FEISOL CM-1401 and CM-1471
A.
Interchanging the Mounting Screw Size
The size of the pre-installed Mounting Screw on the Monopod CM-1401 is ¼", while the size
of the pre-installed Mounting Screw on the Monopod CM-1471 is 3/8". In order to attach Ball
Heads or other accessories which require a different size, the Mounting Screw is reversible
and features both common screw sizes on its two ends (see picture).
To reverse the screw, use the included ¾" Socket Wrench to loosen the ¾" nut at the center
of the base, and remove it by hand. Re-attaching it upside-down, again using the Socket
Wrench, will expose the different size thread on the other end. Caution: Over-tightening the
screw can damage the threaded center of your Monopod's Mounting Plate.
WWW.FEISOL.NET
© FEISOL INC, USA
Page 1 of 3
Advertisement
Related Manuals for feisol CM-1401
Summary of Contents for feisol CM-1401
- Page 1 User Manual ► FEISOL CM-1401 and CM-1471 Interchanging the Mounting Screw Size The size of the pre-installed Mounting Screw on the Monopod CM-1401 is ¼”, while the size of the pre-installed Mounting Screw on the Monopod CM-1471 is 3/8”. In order to attach Ball Heads or other accessories which require a different size, the Mounting Screw is reversible and features both common screw sizes on its two ends (see picture).
- Page 2 C. Ball Head (optional) Installation After making sure that the Ball Head’s Panning Knob is locked, screw the Ball Head into the Mounting Screw by turning it clockwise until it fits snugly. Do not over-tighten. WWW.FEISOL.NET © FEISOL INC, USA Page 2 of 3...
- Page 3 D. Spike (optional) Installation Model CM-1401: Remove the Rubber Cap on the end of the leg by twisting and working it forward – it fits snugly in order to prevent it from coming off accidentally. After it is removed, a thread is exposed at the tip of the leg, into which a Long or Short Spike can be screwed (for use on scratch- sensitive surfaces, remove Spike and replace Rubber Cap).