Epson EPL-N2000 User Manual page 112

Service Req.C nnn
Service Req.E nnn
A controller error (C nnn ) or a print engine error (E nnn ) has
occurred. Write down the error number and turn off the printer.
Wait at least five seconds and then turn it back on. If the error
message still appears, turn off the printer, unplug the power
cord, and contact an authorized EPSON Customer Care Center.
Standby
The printer is in its low power state. If the On Line light is on, it
is still on line and you may send a print job.
Toner Low
The printer is almost out of toner. You should replace the
imaging cartridge soon; see "Replacing the Imaging Cartridge"
in Chapter 5 for instructions.
Toner Out
You must replace the imaging cartridge, as described in
Chapter 5. You can press Continue to print one more page.
Turn Paper
The orientation set for paper in a lower paper cassette is not
correct. Change the orientation setting in the printer driver (or in
the control panel, if you are using the Windows 3.1 EPSONScript
driver). Then press Continue.
Warming Up
The printer is warming up; wait a few moments for it to finish.
6-8 Troubleshooting