Using Hex Dump Mode - Epson EPL-N2000 User Manual

Write Error Card
Write Error SIMM
The printer is not able to write to the PCMCIA card. Do one of
the following: (1) turn off the printer, remove the card, then turn
the printer on again; (2) remove the card while the printer is on,
then press Continue to clear the message; (3) reset the printer by
pressing ALT and Continue at the same time.
Writing Card
The printer is writing data to the PCMCIA card; wait a moment
for it to finish.

Using Hex Dump Mode

Hex dump mode is a special feature that makes it easy for
experienced users to find the cause of communication problems
between the printer and the computer. In hex dump mode, the
printer produces an exact printout of the codes it receives.
Follow these steps to turn on hex dump mode and send a print
job using it:
1. Make sure paper is loaded and the printer is turned off.
2. Hold down the Form Feed button while you turn on the
printer; hold down the button until you see Hex Dump on
the control panel display.
3. Open an application and print a document. Your printer
prints out all the codes it receives in hexadecimal format.
4. To turn off hex dump mode, turn off the printer or reset it by
pressing and holding down the ALT and Continue buttons
at the same time. When Reset All appears on the display,
release the buttons.
Troubleshooting 6-9