When Setting Up The Printer - Epson DFX-9000 Reference Manual

When setting up the printer

Because the printer weights approximately 34 kg (75 lb),
you should not lift or carry it alone. Two people should
carry it by the bottom.
Do not place the printer on an unstable surface or near a
radiator or heat source.
Place the printer on a flat surface. The printer will not
operate properly if it is tilted or placed at an angle.
Do not place this product on a soft, unstable surface like a
bed or a sofa, or a small, enclosed area, as this restricts
ventilation.
Do not block or cover the slots and openings in the printer's
cabinet, and do not insert objects through the slots.
Use only the type of power source indicated on the printer's
label. If you are not sure of the power supply specifications
in your area, contact your local power company or consult
your dealer.
Connect all equipment to properly grounded electrical
outlets. Avoid using outlets on the same circuit as
photocopiers or air control systems that regularly switch on
and off.
Do not use a damaged or frayed power cord.
The power cord should be placed to avoid abrasions, cuts,
fraying, crimping, kinking, and other damage.
If you use an extension cord with the printer, make sure the
total ampere rating of all devices plugged into the extension
cord does not exceed the cord's ampere rating. Also, make
sure the total ampere of all devices plugged into the
electrical outlet does not exceed the electrical outlet's
ampere rating.
8
Safety Instructions