Adjusting The Printing Position - Epson DFX-9000 Reference Manual

Note:
If you enter top-of-form mode right after loading paper, you can set the
loading and top-of-form positions at the same time. (When you use the
optional pull tractor, you cannot adjust the loading position.)

Adjusting the printing position

You may need to adjust the printing position in the middle of a
page, or to adjust the top-of-form position when using labels.
When you move the printing position, you temporarily change
the top-of-form position by the same amount. For example, if
you adjust the printing in the middle of the page so that it falls a
half-inch lower, the next page will begin printing a half-inch
lower as well. The printer remembers this temporary
top-of-form position until the next time you load paper, switch
tractors, or turn off the printer. To adjust the printing position or
top-of-form position, follow these steps:
1. Start printing your document. When you reach the text that
you want to align at a particular spot on the page, press the
Pause button to stop printing.
2. Use the Micro Feed buttons to adjust the position where
you want your next line of text to fall. Press the button once
to feed the paper forward or backward in 1/216-inch
increments, or hold it down to move the paper continuously.
Caution:
c
To adjust the printing position when you are printing on
labels, continuous forms with labels, or overlapping
multi-part forms, use the Micro Feedu button only.
Never feed labels backward through the printer. When fed
backward, labels may easily peel off the backing sheet and
cause a paper jam.
3. When you are finished, press the Pause button to resume
printing your document.
Paper Handling
2
2
2
2
2
2
2
2
2
2
2
31