Epson ColorPage 8000 Quick Reference Manual page 5

Replacing the Photoconductor Unit and
Replacing the Photoconductor Unit and
Waste Toner Collector (Continued)
Waste Toner Collector (Continued)
waste toner
collector
7
Position the unit over the guide rails
inside the printer. Then carefully slide
it all the way in.
8
Turn the small lever on the unit to the left.
9
Turn the large lever clockwise 90 degrees.
The display message appears for only one
consumable part at a time. Check the control
panel display for additional replacement
messages.
front cover
Replacing the waste toner collector
separately
The waste toner collector is replaced each time you replace
the photoconductor unit. However, you may need to
replace the collector separately, as shown.
1
2
3
3
Waste Toner Collector
Grab the handle of the waste toner collector and press
down on the tab above the handle to release the lock.
Then pull out the collector and dispose of it.
Take out a new waste toner
collector (S050020). Hold the
handle of the collector and
insert it all the way into the
slot.
Close the front
cover.
S050020