Initialization; Default Settings - Epson ActionPrinter 4000 User Manual

Initialization

There are two ways that the printer can be initialized (returned to
the default settings) through the hardware and one way through the
software. These are described in the following table.
Hardware initialization
Software initialization

Default Settings

The table below shows the default conditions that become valid
when the printer is initialized.
Item
Top of form position
Left and right margins
Line spacing
Vertical tab position
Horizontal tab positions
VFU channel
Font selection
Condensed mode
Character spacing
Justification
Special printing effects
Graphic mode assignment
The power is turned on.
l
. The printer receives an INIT signal at the parallel
interface (pin 31 goes LOW).
The software sends the ESC @ (initialize the
l
printer) command.
Reset to:
Current paper position
Cancelled
Cleared
Every eight characters
Hardware: The current DIP switch setting
Software: The current SelecType setting
Hardware: The current DIP switch setting
Software: The current SelecType setting
The current DIP switch setting
Left justification
Cancelled (except condensed printing)
ESCK=ESC*0,ESCL=ESC*1,
ESCY=ESC*2,ESCZ=ESC*3
Technical Specifications
I
8-15