Epson ActionLaser 1000 Installation Manual page 5

Selecting PostScript
You need to change the emulation or mode setting through
SelecType before you can use PostScript.
The SelecType instructions below enable you to assign
PostScript quickly. If you need more detailed instructions on
using SelecType, see your printer manual
Note:
Be sure to install the interface and PostScript cards first. Otherwise,
the PostScript emulation or mode aloes not appear as a SelecType
option on the printer display.
For the ActionLaser 1000 and 1500
1. Press the ON LINE button to take the printer off line.
2. Press the SelecType Level 2 button.
3. Press V until EMULATION appears on the display.
Press b.
4.
5. Press V until CH O appears.
Press b.
6.
7. Press V until PS appears.
8. Press F to set the PS emulation.
9. Press the EXIT button twice to return to the READY message.
Note:
The READY message may not show O PS (indicating the
optional interface and PostScript) until after yourfirst print job
is sent from your computer to the printer each time you turn on
your printer.
10. Make sure that AppleTalk is active in the Chooser under the
Apple menu on your Macintosh.
4