Epson ActionLaser 1000 Installation Manual page 4

5. Secure the interface with the two screws provided with
the card.
6. Attach your LocalTalk cable to the LocalTalk port (indicated
by the f icon) on the interface card. (Do not use the serial
port.) Then plug the other end of the cable into your
computer.
7. Plug the power cord into your printer and an electrical outlet.
Installing the PostScript Card
Caution:
1. Make sure the printer is turned off.
2. Hold the card so that the arrow on the card is aligned with
the arrow on slot A. (Do not use slot B.)
3. Gently but firmly slide the card into the slot as far is it can go.
4. Turn on the printer and computer.
card. Otherwise, you may damage it.
ActionLaser 1000/1500
3
EPL-8000