Product Safety Information; Product Specifications - Ingersoll-Rand 301B Product Information

Product Safety Information

Intended Use:
These die grinders are designed for grinding, porting, polishing, de-burring and breaking sharp
edges.
For additional information, refer to Product Safety Information Manual Form 04580288.
Manuals can be downloaded from ingersollrand.com

Product Specifications

Free
Collet Size
Speed
Model(s)
rpm
301B 21000 1/4" (6 mm)
307B 28000 1/4" (6 mm)
302B 20000 1/4" (6 mm)
308B 25000 1/4" (6 mm)
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16573164 and table on page 2. Maintenance frequency is shown in a circular
arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
48483689_ed4
Sound Level dB(A)
(ISO15744)
† Pressure
mm
(L )
p
---
83.0
90.0
92.0
WARNING
Sound Level dB(A)
(ANSI S5.1-1971)
‡ Power † Pressure
(L ) (L )
w p
--- 91.8
94.0 ---
101.0 ---
103.0 ---
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease
Vibration (m/s²)
(ISO28927)
‡ Power
Level
(ISO3744)
104.8 5.9
--- 4.5
--- 5.5
--- 3.7
EN
*K
1.0
1.1
1.5
1.2
EN-1