Installation Instructions - Project Source 51-K814-PS-BN Quick Start Manual

INSTALLATION INSTRUCTIONS

1. Shut off the water at the supply valves under the sink
or at the main water supply. Disconnect the supply
lines. Remove the existing faucet from the sink.
Clean and dry the surface area where the new faucet
will be mounted.
2. Unscrew the quick connector (2.1) from the end of the
spray hose (2.2) by turning it in a counterclockwise
direction. Remove the preassembled lock nut (AA)
and metal washer (BB) from the shank (2.3) on the
faucet body (A).
Hardware Used
Lock nut
AA
BB
Metal washer
3. To install with the optional deckplate for a 3-hole sink,
skip to Step 4.
Before installation, make sure the flange (3.1) is on the
bottom of the faucet body (A). Pull the spray hose (3.2)
up through the faucet body (A) until the end of the hose
is flush with the bottom of the shank (3.3) on the faucet
body (A). Do not pull the fitting on the bottom of the
spray hose (3.2) past the shank (3.3). Carefully insert the
water supply lines (3.4) on the faucet body (A) through
the mounting hole in the sink. Skip to Step 5.
NOTE: Do not feed the spray hose (3.2) back through
the spout (3.5) and faucet body (A) until Step 6.
x 1
1
x
4
1
2
BB
AA
2.2
2.1
3
3.5
3.2
3.1
3.3
A
2.3
A
3.4