Related Manuals for Etesia PKCTM
Summary of Contents for Etesia PKCTM
- Page 1 Original user Please read carefully before using your machine manual PKCTM PHCT - PHCS...
-
Page 2: Table Of Contents
CONTENTS 1• Your safety and that of others ................................3 2• Key to diagrams ......................................5 3• Description ......................................7 4• Pictures ........................................9 5• Technical specifications ..................................14 6• Preparation and getting started ................................15 7• Operating instructions ..................................16 8•... -
Page 3: 1• Your Safety And That Of Others
Any use other than lawn is to be avoided. to the user should also be removed. ETESIA has a policy of continuously improving the quality of its • Before mowing, always clear the lawn of stones, pieces of wood or... - Page 4 ETESIA. difficult. Only buy the amount of fuel you need for one month’s use • Any modification not authorized by ETESIA could render the ma- and keep it in a clean jerrycan set aside for this purpose. chine dangerous and lead to serious injury during use. ETESIA shall accept no responsibility if these instructions are not followed.
-
Page 5: 2• Key To Diagrams
2• KEY TO DIAGRAMS - SAFETY This symbol appears in the instruction manual alongside e) Gasoline is extremely fl ammable and explosive and can cause fi res those sections which deal with user safety. and severe burns. Do not fi ll the fuel tank when the motor is run- ning or hot. - Page 6 (< 3 seconds). • CUTTING HEIGHT STOP position to stop the engine • DRIVE CONTROL LEVER (PKCTM - PHCT) - Cutting height indicator in millimetres. - To move forward, push the control lever against the handlebar.
-
Page 7: 3• Description
(PKCTM) 3• DESCRIPTION 1. Fuel tap 12. Gauge / Oil fi ller tube 2. Air fi lter 13. Mulching insert 3. Fuel tank cap 14. Cutting height indicator 4. Starter 15. Muffl er 5. Double safety lever for blade clutch 16. - Page 8 3• DESCRIPTION (PHCT - PHCS) 12. Muffl er 1. Fuel tank cap 13. Air fi lter 2. Defl ector 14. Spark plug 3. Safety lever (engine brake) 15. Fuel tap 4. Drive control lever (PHCT) 16. Flywheel brake lever 5. Starter 17.
-
Page 9: 4• Pictures
4• PICTURES >... - Page 10 4• PICTURES open close PKCTM PKCTM PHCT - PHCS PKCTM - PHCT MAXI 20°...
- Page 11 4• PICTURES...
- Page 12 4• PICTURES PHCT - PHCS PKCTM...
- Page 13 4• PICTURES ≤ 2 mm 0,70 - 0,80...
-
Page 14: 5• Technical Specifications
0,7 - 0,8 mm Blade coupling device Belt Shear washer Blade stop Blade clutch Engine break Blade ETESIA reference MZ46E Cutting width 46 cm Cutting height Centralised adjustment (28), 38, 48, 58, 68, 78, 88 mm Dimensions (Lxlxh) Handlebar folded :... -
Page 15: 6• Preparation And Getting Started
3 and 3a). • Do not smoke while fi lling with petrol. The tank should always be • The tank capacity is 4 l for the PKCTM model and 0,9 l for the fi lled with the engine switched off. -
Page 16: 7• Operating Instructions
• Remove the dipstick and check the level. The mark left on the Hold on and follow the starter handle back to fi rst position. gauge should not be below the ADD mark for the PKCTM model and below the lower limit of the gauge for PHCT-PHCS mo- STARTING A ENGINE WHICH HAS BEEN RUN- dels. - Page 17 • Slide the extra grills forward to fasten them in place. FORWARD MOVEMENT (PKCTM - PHCT) MOWING WITH THE INSERT (MULCHING • To move forwards, pull the advance lever back firmly against the CONFIGURATION) handlebars (see picture 9).
-
Page 18: 8• Maintenance
• Fill the sump with new oil. The oil level must reach the FULL mark for the PKCTM model and the upper limit of the gauge for PHCT- Wear gloves to avoid any accidents when handling the cutting PHCS models (see §... - Page 19 • It is inevitable that impurities will get into the air fi lter. That is why • Replace the spark plug every 100 (PKCTM) / 250 (PHCT - PHCS) it is essential that you regularly remove the cartridge of the air filter hours of operation or every season as appropriate.
-
Page 20: 9• Long Stop - Winter Storage
In addition to risks incurred by the user, the use of parts other than the manufacturer’s will result in the cancellation of the warranty for any damage caused. ETESIA refuse to accept responsibility for accidents due to the use of... -
Page 21: 11• Regular Maintenance Summary Table
The best maintenance is regular cleaning after each mowing (cutting deck, wheels, engine, cutting heights, transmission system,…). (*) Every 25 hours if the motor is used under tough conditions (dust, heat, heavy loads). (**) These operations must be performed by an ETESIA-authorized dealer-repairer. -
Page 22: 12• Warranty
ETESIA. Should ETESIA (main or secondary residence). not receive these part(s), a warranty claim would automatically be - Professional use = use of an ETESIA machine, in exchange of rejected. money or not, on public areas to maintain companies or institutions like : hospitals, associations,….or on private fields being owned by... - Page 24 13, rue de l’Industrie, 67165 WISSEMBOURG CEDEX declare under our responsibility that the petrol lawnmower, type PRO46, references PKCTM, PHCT and PHCS to which this declaration refers, fulfil all the relevant terms of directive 2006/42/EC applicable to them as well as to the provisions of all other applicable European...
- Page 25 Stamp here please ETESIA SERVICE GARANTIE 13 rue de l'Industrie 67165 WISSEMBOURG CEDEX France...
- Page 26 * In accordance with the data protection act of 06/01/1978 amended by the law of 20/06/2018, the user has a right to have access, rectifica- tion and rejection to the personal information concerning them held by Etesia SAS, this should be made in writing to the following address: ETESIA SAS - Warranty service - 13 rue de l’Industrie - 67160 WISSEMBOURG.