Assembly Preparation; Assembly Instructions; Mounting The Support Legs To Main Cabinet; Securing The Control Panel To Support Legs - Pit Boss V5P1 Assembly And Operation Manual

Wood pellet vertical

Table of Contents

Available languages

Parts are located throughout the shipping carton, including underneath the smoker. Inspect the smoker, parts, and hardware

blister pack after removing from the protective shipping carton. Before assembly of product, review all parts and reference the

parts list. If any part is missing or damaged, do not attempt to assemble. Shipping damage is not covered under warranty. Contact

your dealer or Pit Boss® Customer Service for parts: Monday through Sunday, 4am - 8pm PST (EN/FR/ES).

service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135

IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.

Tools required for assembly: screwdriver and level. Tools not included.

IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws

completely until all screws for that step have been installed, or unless otherwise mentioned.

1. MOUNTING THE SUPPORT LEGS TO MAIN CABINET

Parts Required:

Main Cabinet (#7)

Support Leg With Wheel (#15)

12 x

¼–20x½" Screw ( #B)

Installation:

•

Place a piece of cardboard on the floor to prevent scratching the unit

and parts during assembly. First, lift the main cabinet door off the

hinges, and place aside. Note illustration 1A

•

Next, flip the main cabinet, bottom side pointed upward, on the

cardboard. Prepare the four support legs for installation, arranging

the labeled legs as shown in illustration 1B.

IMPORTANT: The four support legs must be arranged correctly to be

able to properly install the support panels and support bar in a later

assembly step.

•

Mount one support leg to the smoke cabinet using three screws. Repeat

installation for the other three support legs. Note illustration 1C.

2. SECURING THE CONTROL BOARD TO SUPPORT LEGS

Parts Required:

#10–24x½" Screw ( #D)

Installation:

•

Near the Control Board, loosen the two screws connecting the front

panel to the main cabinet. Note 2A.

•

Next, using another two screws, secure the front panel sides to the

front-facing support legs. Once these screws are tight, re-tighten the

two screws that were previously loosened. Note 2B.