Cleaning The Print Head - Epson Stylus CX7400 Series Quick Manual

4. If there are no gaps, press
If there are gaps or the pattern is faint, press x
(see the next section for details).

Cleaning the Print Head

If print quality has declined and the nozzle check pattern indicates clogged
nozzles, you can clean the print head. Print head cleaning uses ink, so clean it only
if necessary.
Note:
You cannot clean the print head if an ink cartridge is expended or low. You must replace
the cartridge first (see page 29).
1. Make sure the CX7400 Series is on and the
2. Hold down the y
starts flashing, then release the buttons. The CX7400 Series runs a head
cleaning cycle, which takes about one minute.
Caution:
Never turn off the CX7400 Series during head cleaning or you may damage it.
3. When the P
page 26) to verify that the print head is clean.
4. If there are still gaps or lines, or the test patterns are faint, run another
cleaning cycle and check the nozzles again.
Note:
If you don't see any improvement after cleaning the print head two times, turn off your
CX7400 Series and wait at least six hours to let any dried ink soften. Then try printing
again.
If you do not use your CX7400 Series often, it is a good idea to print a few pages at least
once a month to maintain good print quality.
to continue printing.
OK
button for at least 3 seconds until the P
Stop
light stops flashing, run a nozzle check (as described on
On
to clean the print head
Start
ink light is off.
B
Cleaning the Print Head
light
On
27