Equipment Dismounting Steps And Precaution; Notices For Wiring; The General Wiring Diagram Of Switch Box, Inverter And Motor - ASL INTERCOM T330 Manual

[2]: Ensure to clean ground dust.

3.4 Equipment Dismounting Steps and Precaution

3.4.1 Carrying Steps
[1]: First, ensure machine is disconnected from power
[2]: Ensure vacuum cleaner is disconnected.
[3]: Use the lifting handle on the front of the machine to make sure the head isn't dragging.
[4]: One person lifts the metal bar on the front of the machine, and one person lifts from the machine handle. Two
people together lift the machine at the same time.
3.4.2 Notes for Carrying
[1]: Before carrying the machine, make sure the power switch is in off state.
[2]: When carrying, please act lightly and carefully so as to avoid collision with small parts and the wall; if
one person can't complete this operation independently, please deploy other persons to assist.
[3]: When break-down for shipping, be sure to store all dismounted parts or screws to prevent loss.
Chapter IV
Equipment Wiring and Inverter Reset
Wiring the equipment, please be sure to operate strictly as per the following instruction, so as to prevent unnecessary loss.

4.1 Notices for Wiring

[1]: If self-wiring, wiring must be operated under the instruction of professional electricians or the technicians of the
manufacturer.
[2]: The electrical system of this equipment must strictly follow the parameters (voltage and frequency) designated on the
nameplate, and before being connected with the input power, please check to ensure the voltage and the frequency of the
external power supply are coincident.
[3]: This equipment must be connected to the power system equipped with grounded electrically to prevent electric shock of
the operator.
Note: The power wire (220V) of this equipment is equipped with 3 main traverse wire, 1 ground wire and 1 null wire. Connect
the plug into appropriate power socket. The green-and-yellow core wire in the power wire is the ground wire, and don't
connect the ground wire to non-power socket.
4.2 The general wiring diagram of switch box, inverter and
motor
8