ASL INTERCOM T330 Manual page 14

Access fault of display
E0022 panel EEPROM
E0023 Fault setting of
parameters
E0024 Fault of external
equipment
E0025 PID reference loss
E0026 PID feedback loss
E0027 PID feedback out of
limiting
SCI communication
E0028 time- out
E0029 SCI communication
error
ï Memory circuit fault of display
panel EEPROM
ï The power rating between motor and
inverter is too different
ï Improper setting of motor parameters
ï Fault terminal of external
equipment operated
ï Analogue reference signal is
smaller than F20.12
ï Analogue input circuit fault
ï Analogue setting signal is
smaller than F20.14
ï Analogue input circuit fault
ï Analogue setting signal is bigger
than F20.16
ï Analogue input circuit fault
ï Connection fault of
communication cable
ï Disconnected or not well connected
ï Connection fault of
communication cable
ï Disconnected or not well connected
ï Communication setting error
ï Communication data error
ï Replace the display panel
ï Please contact the
supplier for repairing
ï Select an inverter
with suitable power
rating
ï Please set correct value
of motor parameters
(F08.00-F08.04,F13.01-
F13.05)
ï Please Check
external equipment
ï Please check the
connection
ï Please seek technical
support
ï Please check the
connection
ï Please seek technical
support
ï Please check the
connection
ï Please seek technical
support
ï Please check the
connection
ï Please check the
connection
ï Please correctly set the
communication format
(F17.00) and the baud
rate (F17.01)
ï Send the data according
to MODBUS protocol
14