Table of Contents
Advertisement
Install DSM on RackStation
After hardware setup is finished, please install DiskStation Manager (DSM) –
Synology's browser-based operating system – on your RackStation.
Install DSM with Web Assistant
Your RackStation comes with a built-in tool called Web Assistant that helps
you download the latest version of DSM from the Internet and install it on your
RackStation. To use Web Assistant, please follow the steps below.
1 Power on the RackStation.
Note:
If you set up two RackStation units to create a HA cluster, we highly
recommend to power on both the RackStation before proceeding with the DSM
installation.
2 Open a web browser on a computer connected to the same network as the
RackStation unit(s).
3 Enter either of the following into the address bar of your browser:
a
find.synology.com
b
rackstation:5000
4 Web Assistant will be launched in your web browser. It will search for
and find the RackStation within the local area network. The status of the
RackStation should be Not Installed.
5 Select either of the RackStation units, and click Set up to start the setup
process and follow the onscreen instructions. This RackStation will serve as
active server after installation.
Note:
1. If you are informed that the installation has started on the other server, simply
follow the onscreen instruction to proceed with the setup process.
2. The RackStation must be connected to the Internet to install DSM with Web
Assistant.
3. Suggested browsers: Chrome, Firefox.
4. Both the RackStation units and the computer must be in the same local area
network.
3
Chapter
14
Advertisement
Table of Contents
