Table of Contents
Advertisement
To make sure RackStation recognizes the new memory capacity:
1 Log in to DSM as admin or a user belonging to the administrators group.
2 Check Total Physical Memory in Control Panel > Info Center.
If your RackStation does not recognize the memory or does not start up
successfully, confirm that the memory is installed correctly.
To remove the RAM module:
Note:
Once you remove a RAM module from either of your RackStation units in
a HA cluster (if created), you must remove the corresponding RAM module from
the other RackStation.
1 Follow step 1 and 2 of the "To install the RAM module" section to shut down
your RackStation, disconnect the cables, and then remove the top cover.
2 Disengage the memory retaining clips by pushing them outwards, and the
module will pop out of the slot.
3 Follow step 4 of the "To install the RAM module" section to put back the top
cover.
Replace Malfunctioning PSU
If a power supply unit (PSU) malfunctions, please see the instructions below to
replace the PSU.
1 Unplug the power cord from the PSU to be replaced.
By pressing the Beep Off button, you can silence the long beeping sound
Note:
when you hear it.
2 Push the lever of the PSU at the back panel in the indicated direction.
3 Pull out the PSU from the RackStation.
4 Prepare a new PSU, and push it back to the slot until you hear a click.
Chapter 4: Maintenance and Expansion
23
Advertisement
Table of Contents
