Install Software - Epson AcuLaser CX11N Start Here Manual

4
With Lang = XXXX selected, press the button.
5
Use the or
the button.
5
Load Paper/Verify Settings
1
Paper Out appears in the LCD screen. Open the MP Tray and place a
stack of up to 80 sheets of paper in the tray. Adjust the paper guide on
the right so that it is snug against the stack. Then close the cover.
2
Press the
The Setup light turns on and the
LCD screen shows Setup Mode
for a few seconds, then changes
to the Setup menu screen.
3
While Printer Settings is
highlighted, press the
4
While Information Menu is
highlighted, press the
5
While Status Sheet is highlighted, press the
A Status Sheet is printed.
6
If you have the CX11NF, place the Status Sheet face up on the Auto
Document Feeder.
If you have the CX11N, place the Status Sheet face down on the
document table.
7
Press the
8
Press the B&W Start button.
The Status Sheet is copied.
6

Install Software

CX11N as a Local Printer
See "CX11N as a Network Printer" for information on setting up the CX11N as
a network printer.
Windows
®
1
Make sure the CX11N is not
connected to your computer.
Note: If you see a screen like this,
click Cancel and disconnect the
USB cable. You cannot install your
software that way.
2
Insert the Epson CD-ROM into the
CD drive of your computer.
3
Make sure you close all other
applications. When you see the
following screen, click Continue.
4
Read the license agreement that
appears and click Agree.
5
For the type of installation,
select Local.
button to select the desired language, then press
Setup button.
button.
button.
Copy button on the control panel to enter the Copy mode.
button.
Turn over