Install Toner Cartridges - Epson AcuLaser CX11N Start Here Manual

9
Connect the power cord to the
CX11N and to an AC outlet.
10
Push the power switch to On.
2

Install Toner Cartridges

Caution: Make sure the CX11N is turned on before installing the toner
cartridges. Do not install the photoconductor before installing the toner
cartridges.
1
Open cover A and remove the
tape and plastic insert.
2
In the LCD screen the message
Install [X] Toner Cartridge
appears, where [X] is one of
the following:
•
Y: Yellow
•
M: Magenta
•
C: Cyan
•
K: Black
3
Remove the toner cartridge from its
package and gently shake it.
Warning: Do not touch the toner. Keep
the toner away from your eyes. If toner
gets on your skin or clothes, wash it off
with soap and water immediately.
4
Hold the tag and gently pull the toner seal
until it comes completely out.
5
Slide the toner cartridge into the tracks inside the printer. Push evenly on
both sides until the cartridge stops securely in its slot.
If the cartridge doesn't
seem to be installed fully,
remove it and reinstall it.
Caution: Don't force the
cartridge into the printer
or force the lock lever
down, or you may damage
the printer.
6
Push down the lever to
lock the toner cartridge.
Note: The toner cartridge
is installed securely when
you cannot turn the lock
lever any further.
7
Close cover A and confirm the message in the LCD screen.
The LCD screen will display the next cartridge that needs to be
installed. Open cover A and repeat steps 3 to 7 for each of the
remaining toner cartridges.