Advertisement
3
Install ink cartridges
Caution:
Keep the ink cartridges out the reach of children and do not
drink the ink.
1
Lift up the scanner unit until it locks.
Caution:
Do not touch the flat, white cable.
2
Gently shake the ink cartridges.
3
Unpack the ink cartridges.
4
Remove only the yellow tape from each ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
Do not touch the green chip on the cartridge.
5
Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
6
Lower the scanner unit.
7
If prompted, follow the instructions on the LCD screen.
The printer starts charging the ink. Ink charging takes
approximately 5 minutes. When you see a completion
message on the printer's LCD screen, charging is
complete.
Caution:
Don't turn off the printer or raise the scanner unit while
the printer is charging or you'll waste ink.
Note:
• The printer is designed for use with Epson cartridges only, not
third-party cartridges or ink.
• The cartridges included with the printer are designed for
printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
• As part of setup, your product's serial number will be sent to a
secure Epson server so that you can be eligible to participate
in programs we may offer from time to time, including the
Epson ink replenishment program. You will have a separate
opportunity to consent to participating in such programs.
4
Load paper
1
Make sure the product is done charging the ink, and then
close the control panel, lift the output tray, and pull out a
paper cassette.
2
Slide the side edge guides all the way out and set the
front edge guide to the paper size you are using.
Advertisement
