Emergency Stop Button; Keyed Safety Reset Switch; Safety Pre-Reset Button - Acer Wood Runner Manual

Table of Contents

6.2 EMERGENCY STOP BUTTON

Located on the operators console next to the operators screen. Depressing the button causes an E-stop to

be triggered. Twist the button clockwise and pull slightly to reset it.

Emergency Stop Button & Keyed

Safety Reset Switch

This switch has 3 positions. "OFF" removes power from the operator's console but does not remove power

from the Main Enclosure. "ON" boots the computer and powers other machine functions. "Reset" causes

the safety system to reset if the required conditions are met.

This button is located inside the HAZARDOUS ZONE. Its purpose is to protect personnel who are within the

HAZARDOUS ZONE by preventing a system safety reset by someone outside the HAZARDOUS ZONE. The

button must be pressed by the last person leaving the HAZARDOUS ZONE. After pressing the Pre-Reset

button you will have 12 seconds to break the light curtain upon leaving and reset the safety system using

the keyed reset switch on the operator's console. If the reset switch is not operated within the required

time it will be necessary to push the pre-reset button and break the Light Curtain again. Never attempt to

reset the system if someone else is still within the HAZARDOUS ZONE as moving machinery could cause

serious injury or death. You will need to repeat the procedure if a reset does not occur within the 12

seconds. This timing is not adjustable. The Pre-Reset button is only necessary when the Light Curtain or

Brake Beam has been broken. An E-stop caused by the E-stop button can be reset without the Pre-Reset

button if the Light Curtain or Brake Beam has not been broken.

Safety Pre-reset Button

Table of Contents