Acer Wood Runner Manual page 22

 Connect Ethernet and I/O wire between the Operators console and the Main Electrical Enclosure. Both
ends of the Ethernet cable route through the same type of aluminum connect that was used on the
Gantry. These wires are typically routed through the frame of the Infeed Deck.
 Mount the Light Curtain receiver to its bracket near the saw and mount the emitter to the Forklift Guard.
The receiver has an 8 pin electrical connector; the emitter has a 5 pin connector. The emitter cable is
located in the lower Runway tube and must be fastened along the Perimeter Guard to protect it from
damage. The receiver cable originates from the Operators console. The light curtain will need to be
aligned after the machine is powered up. See the Startup section.
Infeed Deck Power Connection
22