Mounting The Trfot-2 - Cabletron Systems TRFOT-2 User Manual

INSTALLING THE TRFOT-2

3.6 MOUNTING THE TRFOT-2

To wall-mount the TRFOT-2, use the Cable Mounts, Tie Wraps, and
Velcro Strips included with the unit. Refer to Figure 3-5 and perform
the following steps:
1. Remove the tape from the adhesive backing on the Velcro strips.
2. Place one Velcro half on the TRFOT-2 and the other half on the
mounting surface.
3. Press firmly on each Velcro strip, then press the TRFOT-2 onto the
mounting surface.
4. Secure the TRFOT-2's cables to the wall using the adhesive backed
cable mounts and tie wraps.
Page 3-6
Figure 3-4. Attaching the Power Supply
TRFOT-2
POWER
INPUT
802.5 TOKEN RING COPPER
TRANSCEIVER
A B C D
Figure 3-5. Mounting the TRFOT-2
FIBER OPTIC
TO
®
LANVIEW
WITH
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
POWER REQUIRED: 9-12V ----,500mA MAX
DATA CAPABILITY: 4/16Mb/s AUTO SENSING
SN U L SA
Cable Mounts and Tie Wraps
C
P F
U
O
W
R
LNK
TX
RX