Chapter 3 Installing The Trfot-2; Unpacking The Trfot-2; Setting The Configuration Switches - Cabletron Systems TRFOT-2 User Manual

This chapter outlines how to install the TRFOT-2 in your network.
Ensure that your network meets all the requirements listed in
Chapter 2, Installation Requirements/Specifications, before
installing and operating the TRFOT-2.

3.1 UNPACKING THE TRFOT-2

Unpack the TRFOT-2 as follows:
1. Carefully remove the TRFOT-2 from the shipping box.
2. Remove the TRFOT-2 from its protective plastic bag.
3. Visually inspect the TRFOT-2. If there are any signs of damage,
contact Cabletron Systems Technical Support immediately.

3.2 SETTING THE CONFIGURATION SWITCHES

Figure 3-1 shows the location of the TRFOT-2's four configuration
switches. Cabletron sets the switches for Station applications. If you
need to change the switches for other applications, follow steps 1-3.
A
Figure 3-1. TRFOT-2 Configuration Switches
1. Disconnect the TRFOT-2 from the network and remove the power.
2. Set the switches for the desired application (refer to Table 3-1).
3. Reconnect the TRFOT-2 to the network, then re-apply the power.
CHAPTER 3
INSTALLING THE TRFOT-2
B C D
OFF
ON
INSTALLING THE TRFOT-2
Page 3-1