Before First Use - AEG FSK32610Z User Manual

Hide thumbs Also See for FSK32610Z:
Table of Contents

Advertisement

12
www.aeg.com
off.
on.
3. Press the programme button to
change the setting.
4. Press the on/off button to confirm the
setting.
6.5 AirDry
AirDry improves the drying results with
less energy consumption. During the
drying phase, the door opens
automatically and remains ajar.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
opening. This can cause
damage to the appliance.

7. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in
the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
is off = The acoustic signal is
is on = The acoustic signal is
AirDry is automatically activated with all
programmes excluding
applicable).
The duration of the drying phase and the
door opening time vary depending on the
selected programme and options.
CAUTION!
If children have access to
the appliance, it is advised to
deactivate AirDry as opening
the door may pose a danger.
How to deactivate the AirDry
Make sure the appliance is in user mode.
1. Press the programme button three
times.
The indicator
starts to flash.
2. Wait until the indicator
to flash and the remaining
programme indicators are off.
The indicator
shows the current
setting:
is off = AirDry is off.
is on = AirDry is on.
3. Press the programme button to
change the setting.
4. Press the on/off button to confirm the
setting.
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
7.1 The salt container
CAUTION!
Use rough salt designed for
dishwashers only. Fine salt
increases the risk of
corrosion.
The salt is used to recharge the resin in
the water softener and to assure good
washing results in daily use.
(if
continues

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents