Before First Use - AEG FFX52507ZW User Manual

AirDry is automatically activated with all
programmes other than
The duration of the drying phase and the door
opening time vary depending on the selected
programme and options.
CAUTION!
Do not try to close the appliance door
within 2 minutes after automatic opening.
This can cause damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running programme
ends.
CAUTION!
If children have access to the appliance,
we advise to deactivate AirDry. The
automatic opening of the door may pose
a danger.
How to deactivate AirDry
The appliance must be in programme
selection mode.

7. BEFORE FIRST USE

1. Make sure that the current level of the
water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not put dishes in the
baskets.
After starting the programme, the appliance
recharges the resin in the water softener for
up to 5 minutes. The washing phase starts
only after this procedure is complete. The
procedure is repeated periodically.
12 ENGLISH
(if applicable).
Make sure that the programme marker on the
knob is set to the on/off position.
1. To enter the user mode, press and hold
. At the same time turn the knob
counterclockwise until the programme
marker indicates the first programme.
Release when the indicators
on/off start flashing.
2. Turn the knob counterclockwise until the
programme marker indicates the third
programme.
The indicator shows the current setting:
• is on = AirDry is activated.
• is off = AirDry is deactivated.
3. Press to change the setting.
4. To confirm the setting, keep turning the
programme knob until the programme
marker is back in the on/off position.
7.1 The salt container
CAUTION!
Use only regeneration salt for
dishwashers. Do not use kitchen salt.
The salt is used to recharge the resin in the
water softener and to assure good washing
results in daily use.
7.2 How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container
(only for the first time).
3. Fill the salt container with 1 kg of salt
(until it is full).
and