Safety Instructions; Basic Safety Instructions - JAUDT DPK GII 6207 Series Translation Of The Original Operating Instructions

Operating instructions DPK 6207...
2

Safety instructions

You must make sure that the local health and safety regulations are observed.
JAUDT double shuttle valves (DPK) conform to the very latest state of the art. Nevertheless, personal injury
and material damage can be caused by moving parts or carelessness. We warn you of this through the
corresponding advice. This advice is emphasised by the use of particular symbols.
Danger of death!
This symbol alerts you to a danger that constitutes a risk to personnel from electrical power.
Danger of injury!
This symbol alerts you to a danger that constitutes a risk to personnel.
Danger of material damage!
This symbol alerts you about action that may cause damage to the JAUDT double shuttle
valve.
This dot prompts you to carry out a specific action.
·
The order of these actions must be followed to the letter.
2.1

Basic safety instructions

Installation may only be performed by trained personnel who are familiar with these assembly
instructions. Electrical work may only be carried out by approved trained electricians.
Only use the device for the intended use according to the order and type identification plate!
Note the manufacturer's specifications for drives and accessories!
For devices to which RL94/9/EC (ATEX) applies, also observe the additional instructions (ATEX
supplement)!
Wear the safety shoes and personal protective equipment specified in your internal plant regulations
when carrying out the relevant work! Observe your operating and work instructions.
For foodstuffs, cosmetics and pharmaceuticals, observe the internal plant regulations for substances,
cleaning and hygiene.
Prior to installation, ensure that the bulk goods system is emptied and protected against inadvertently
being started up.
Use approved lifting tackle and slings with sufficient carrying capacity for installation! In particular,
ensure that drives, accessories, cables and protruding machine parts are protected against damage
during installation.
© BA_DPK_EN_Rev06-2010.docx Page 5 of 18