Adjusting The Fastening Torque; Installing Hook - Makita XFD15 Instruction Manual

Adjusting the fastening torque

1
1. 2. Graduation 3. Arrow
The clutch will slip at various torque levels when set at the number 1 to 20. The clutch does not work at the
torque level is required for a particular application.
The following shows the rough guide of the relationship between the screw size and graduation.
Graduation 1 2
Machine screw
Wood Soft wood
screw (e.g. pine)
Hard wood
(e.g. lauan)
ASSEMBLY
CAUTION:
Always be sure that the tool is
before carrying out any work on the tool.
Installing or removing driver bit/drill bit
Optional accessory
1
2
1. Sleeve 2. Close 3. Open
Place the driver bit/drill bit in the chuck as far as it will go.
Turn the sleeve clockwise to tighten the chuck. To remove
the driver bit/drill bit, turn the sleeve counterclockwise.
2
3
3 4 5 6 7 8 9
M4 M5
– ø3.5 x 22
– ø3.5 x 22

Installing hook

their intended purposes only. Using for unintended
3
This can be installed on either side of the tool. To install
the hook, insert it into a groove in the tool housing on
either side and then secure it with a screw. To remove,
loosen the screw and then take it out.
8 ENGLISH
marking.
10 11 12 13 14 15 16
ø4.1 x 38
ø4.1 x 38
CAUTION:
When installing the hook, always
CAUTION:
Use the hanging/mounting parts for
1
2
3
1. Groove 2. Hook 3. Screw
marking.
17 18 19 20
M6
–
–