Setting A Programme; Starting A Programme With The Delay Start - Zanussi ZWT816PCWA User Manual

CHECK THE POSITION OF THE DETERGENT
FLAP
1. Pull out the detergent dispenser until it stops.
2. Press the lever down to remove the dispenser.
3. To use powder detergent, turn the flap up.
4. To use liquid detergent, turn the flap down.
With the flap in the position DOWN:
• Do not use gelatinous or thick liquid
detergents.
• Do not exceed to liquid detergent dose
indicated on the flap.
• Do not set the prewash phase.
• Do not set the delay start function.
5. Measure out the detergent and the fabric
conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause a blockage
when you close the drawer.
26

SETTING A PROGRAMME

1. Turn the programme dial to select the desired
washing programme.
The indicator of Modo - Lavar button illuminates.
The indicator of the Inicio/Pausa
flashes.
The display shows an indicative programme
duration and the maximum load.
2. To change the temperature and/or the spin
speed, touch the related buttons.
3. If desired, set one or more options by touching
the related buttons. The related indicators
illuminate on the display and the given
information changes accordingly.
If a selection is not possible an
acoustic signal sounds and the display
shows
STARTING A PROGRAMME
Touch the Inicio/Pausa
programme. It is not possible to start the
programme when the indicator of the button is off
and doesn't flash (e.g. the door is open).
The related indicator stops flashing and stays on.
The programme starts, the door is locked. The
display shows the indicator
The drain pump can operate shortly
before the appliance fills water.
STARTING A PROGRAMME WITH THE DELAY
START
1. Touch the Inicio Diferido button repeatedly until
the display shows the desired delay time. The
related indicator comes on.
2. Touch the Inicio/Pausa
appliance door locks and starts the countdown
of the delay start. The display shows the
indicator .
When the countdown is completed, the programme
starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Inicio/Pausa
appliance. The related indicator flashes.
2. Touch the Inicio Diferido button repeatedly until
the display shows .
3. Touch the Inicio/Pausa
start the programme immediately.
button
.
button to start the
.
button. The
button to pause the
button again to