Zanussi ZWT816PCWA User Manual page 10

You can extend the drain hose to maximum 400 cm. Contact the service centre for the other
drain hose and the extension.
BUILDING IN
min. 600 mm
min.
560 mm
min.
820 mm
10
Ø 40 mm
L
16-22 mm
To a stand pipe with vent-hole
Directly into a drain pipe at a height of not less than
60 cm (23.6") and not more than 100 cm (39.3").
The end of the drain hose must always be ventilated ,
i.e. the inner diameter of the drain pipe (min. 40 mm -
min. 1.6") must be larger than the external diameter
of the drain hose.
To a sink spigot
Put the drain hose in the spigot and tighten it with
the supplied cable tie L.
Make sure that the drain hose makes a loop to pre-
vent particles going into the appliance from the sink.
To a wall-pipe
Directly to a built-in drain pipe in the room wall and
tighten it with the supplied cable tie L.
This appliance has been designed to be built into the
kitchen furniture. The recess should have the dimen-
sions shown in this picture.
For recess with a height different than
820 mm, it is possible to buy the appro-
priate kit on the website.