Table of Contents
Advertisement
IOT-G65 also supports 802.3af standard PoE and can be powered by PoE switch or PoE
adapter. When connecting, Ethernet cable of IOT-G65 device side should be installed first,
otherwise,or PoE devices or gateway may be damaged.
3.3 Antenna Installation
For external antenna version, rotate the antenna into the antenna connector accordingly.
The external antenna should be installed vertically always on a site with a good signal.
3.4 Gateway Mounting
The gateway can be mounted to a wall or a pole. Please complete all software configurations
before installation.
3.4.1 Wall Mounting
Preparation: mounting bracket, bracket fixing screws, grounding screw, wall plugs, wall
mounting screws and other required tools.
1. Before you start, make sure that your SIM card has been inserted, your antennas have
been attached and that all cables have been installed.
Note: Do not connect device to power supply or other devices.
2. Align the mounting bracket horizontally to the desired position on the wall, use a marker
pen to mark four mounting holes on the wall, and then remove the mounting bracket from
the wall.
Note: The connecting lines of adjacent points are at right angles.
3. Drill four holes with a depth of 32 mm by using your drill with a 6 mm drill bit on the
Advertisement
Table of Contents
