Table of Contents
Advertisement
Ethernet
ETH
Port Status
2.4 Reset Button
Description
Function
STATUS LED
Static Blue
Static Blue →
Reset
Rapidly Blinking
Off → Static Blue
3. Hardware Installation
3.1 SIM Card Installation
IOT-G
65 does not support hot plugging, please turncut off the power before you
insert or take off cards.
A. Use screwdriver to Open the protective cover on the back panel of IOT-G65 via
screwdriver.
B. Push Insert the SIM card into the device according to the direction the icon on the device.
Note: If you need to take out the SIM card, press into the SIM card and it will pop up
automatically.
3.2 Ethernet Cable & Power Cable Installation
A. Connect the Ethernet cable and power cable to corresponding interfaces.
B. Pass two cables through the waterproof silicone and slid into the grooves.
C. Screw the protective cover back to the device.
Static: SIM card has been registered and dialed up
successfully
Off
Disconnected
Blue Light
Static: Connected
Action
Press and hold the reset button for more than 5 seconds.
Release the button and wait.
The gateway resets to factory default.
Advertisement
Table of Contents
