Inspecting Idle Speed - Yamaha Z200 Operator's Manual

Hide thumbs Also See for Z200:
Table of Contents

Advertisement

Maintenance
to slowly break down and erode.
1.
Remove the spark plug caps from the
spark plugs.
2.
Remove the spark plug. If electrode ero-
sion becomes excessive, or if carbon
and other deposits are excessive, you
should replace the spark plug with an-
other of the correct type. WARNING!
When removing or installing a spark
plug, be careful not to damage the in-
sulator. A damaged insulator could
allow external sparks, which could
lead to explosion or fire.
Standard spark plug:
BKR7EKU
3.
Be sure to use the specified spark plug,
otherwise the engine may not operate
properly. Before fitting the spark plug,
measure the electrode gap with a wire
thickness gauge; replace it if out of spec-
ification.
2
1. Spark plug gap
2. Spark plug part number
3. Spark plug I.D. mark (NGK)
Spark plug gap:
1.5–1.6 mm (0.059–0.063 in)
4.
When fitting the plug, wipe off any dirt
from the threads, and then screw it in to
76
[EWM00561]
3
ZMU01892
the correct torque.
Spark plug torque:
25.0 Nm (2.55 kgf-m, 18.4 ft-lb)
TIP:
If a torque-wrench is not available when you
are fitting a spark plug, a good estimate of
the correct torque is 1/4 to 1/2 a turn past fin-
ger-tight. Have the spark plug adjusted to the
correct torque as soon as possible with a
torque-wrench.
EMU29044

Inspecting idle speed

EWM00451
WARNING
Do not touch or remove electrical parts
G
when starting or during operation.
Keep hands, hair, and clothes away
G
from the flywheel and other rotating
parts while the engine is running.
ECM00490
NOTICE
This procedure must be performed while
the outboard motor is in the water. A
flushing attachment or test tank can be
1
used.
If the boat is not equipped with a tachometer
for the outboard motor, use a diagnostic ta-
chometer for this procedure. Results may
1
vary depending on whether testing is con-
ducted with the flushing attachment, in a test
tank, or with the outboard motor in the water.
1.
Start the engine and allow it to warm up
fully in neutral until it is running smooth-
ly.
2.
Once the engine has warmed up, verify
whether the idle speed is set to specifi-
cation. For idle speed specifications,
see page 13. If you have difficulty verify-
ing the idle speed, or the idle speed re-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lz200

Table of Contents