Table of Contents
Advertisement
2. Port engine speed is slightly higher
3. Engine speed is synchronized evenly
between port and starboard engines
4. Starboard engine speed is slightly higher
5. Starboard engine speed is higher
If the two engines' speeds are not synchro-
nized while cruising, adjusting trim angle or
throttle can synchronize them.
If large differences in trim angle or throttle
are needed to synchronize the engines, con-
sult your Yamaha dealer for adjustments to
the throttle cables.
EMU26471
Analog tachometer
This gauge shows the engine speed and has
the following functions.
1. Tachometer
2. Oil level indicator
EMU26541
Oil level indicators (three indicators)
The indicators on the gauge show the status
of the oil level. For details on how to read the
indicators, see page 54.
ECM00030
NOTICE
Do not operate the engine without oil. Se-
rious engine damage will occur.
Instruments and indicators
1. Oil level indicators
EMU26611
This gauge shows the trim angle of your out-
board motor.
1
2
ZMU04577
Memorize the trim angles that work best for
your boat under different conditions. Adjust
the trim angle to the desired setting with the
power trim and tilt switch.
EMU31642
Command link multifunction
Command link multifunction meters have 6
kinds of meter units; tachometer unit (square
or round types), speedometer unit (square
type), speed & fuel meter unit (square or
round types), and fuel management meter
(square type). The indicator system is slight-
ly different between the round and square
types. Check the model and type of your unit
Analog trim meter
meters
1
ZMU04580
ZMU04581
35
Advertisement
Table of Contents
